VTube-LASER v1.57

Revision 1.57 Back to VTube-LASER

NEW: Part Name in Toolbar

The part name is now in the toolbar.

.

ENHANCED - Bender Setup Menu With Springback Values

The Bender Setup menu now includes columns for springback adjustment calculations where you can view how much the part is changed by the springback values. These values are automatically calculated in this menu from the Part Setup "Fixed" and "Proportional" Springback values.

NEW - Overbend Calculator Included In Installation

Use the Overbend Calculator to calculate springback values for Part Setup in VTube-LASER.

ENHANCED - Bender Setup Menu Column Color Changes

The Bender Setup menu shows color columns for any column with data that can be edited on the fly. Gray columns are not editable in the grid.

ENHANCED - Bender Setup Menu Popup Menu for Rotations

Sometimes the corrected rotation value may move in the wrong direction. The Bender Setup menu has new popup menus for the rotation and rotation adjust cells that allow you to quickly invert the rotation to change the rotation directions (to help in bender setup).

ENHANCED - New Fields in the Reports

The reports have fields added - like "comments", and "wall".

An XYZ deviation chart can now be programmed into the reports:

FIX - Cylinder Fit Tolerances Saved to Project File

The Cylinder Fit tolerances are now save to project files.

ENHANCED - Other Changes

• The LRA bender adjustment values automatically recalculate every time a project file is loaded.
• The Part Setup grid cells resize vertically if text no longer fits.
• The caption in VTube-LASER updates to the correct file name after a file save.

Other Pages

• Back to VTube-LASER