CNC Bender v12.1.2

v12.1.2 - August 30, 2013 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

ENHANCED: Motion Recovery Logic

Motion-recovery is the ability for CNC Bender to temporarily pause motion with CYCLE HOLD or entering a safety device, like stepping on a safety mat, then start finish the motion when CYCLE STARTING the bender.

Old Behavoir

CNC Bender attempts motion-recovery in every mode - even MANUAL mode.

New Behavoir

CNC Bender no longer attempts to recover paused (CYCLE HOLD is activated) motion in these circumstances:

• The bender is in MANUAL mode or is switching from STEP or AUTO into MANUAL mode.
• The bender has encountered a FAULT condition.
• The bender has encountered a command that is timed out.
• The E-Stop is pressed.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands