Revision: Benderlink for Chiyoda/Keins 6.7
|
Revision 6.7Back to Benderlink for Chiyoda |
|
ENHANCED - New Serial Port COM Engine Available
This Benderlink can use either the new WinSoft COM engine for faster communications, or the older MarshallSoft COM engine for cases where the older engine works better.
The Benderlink.ini file is found in the c:\Users\[username]\AppData\Roaming\BenderlinkChiyodaKeins folder.
Edit the Benderlink.ini in a notepad editor. The section to change is Communications Setup "COM Engine". These are the two available setups:
[Communications Setup] COM Engine=WinSoft
or
[Communications Setup] COM Engine=Marshallsoft
ENHANCED - New CONVERSION Menu Option: Ignore Diameters with Zero
Benderlink can now ignore radii values of zero by unchecking the option in the main conversion window.
If the zero diameter is ignored, then Benderlink will automatically set the diameter to non-zero using this formula:
(Rad Level 1) / 1.5
If the Rad Level 1 value is zero, then Benderlink will use this formula:
(Rad Level 2) / 1.5
If both radius level values are zero, then Benderlink will set the diameter to 1 unit.
A non-zero diameter is important for when you communicating with ROMER DOCS software because DOCS will report a corrupted file if it senses a zero radius. (This is not an issue in VTube-LASER - it can ignore the diameter of zero.)
OTHER PAGES
- Back to Benderlink for KEINS
- Back to Benderlink for Chiyoda
- Benderlink for Chiyoda FAQ
- About Chiyoda - See this page for control version information.
