VTube-STEP v2.3

Revision 2.3 Back to VTube-STEP Back to VTube-STEP Revisions Back to VTube Software Updates (for LASER Mode) Back to VTube-LASER

• See VTube-STEP Customer Support Page to download the latest version.

NEW: Springback-Compensated LRA Grids

Both VTube-STEP and VTube-LASER now have Springback-Compensated grids in the Tube data, Master Tube data, and the Measured Tube data menus. Also, the new grids have popup menus that allow you to copy any part of the grid. VTube uses the FIXED and PROPORTIONAL springback variables in the Part Setup menu to calculate the springback compensated values in these grids.

NEW: Multi-Elongation Percentage Compensation Setup

VTube-STEP now allows each bend to have a unique tube elongation percentage - which is used to calculate correct CUT LENGTHS and UNBENDING LENGTHS Use the popup menus in either the PART SETUP or the XYZ grids to get to the setup window. A new checkbox is added at the bottom of Part Setup to allow this feature to be activated. If the checkbox is unchecked, then the single Tube Elongation % value is used to calculate elongation for all bends.

FIX: Springback Compensation for Bender Output

When VTube-STEP calculated springback into bender values, it incorrectly doubled the springback values. This has been repaired.

ENHANCEMENT: Springback Compensation Calculation in the Outgoing Bender Data Is Now Optional

This feature adds springback compensation into the outgoing LRA data. In previous versions it was not optional. For some benders (for example, the Eaton Leonard Lightspeed) this addition is NOT recommended because this causes the springback to be added by both VTube and the bender. This doubles the compensation - which is incorrect. If you're not sure if you should use this option, then test how your bender uses the springback compensation values by entering non-zero Springback values in VTube's Part Setup menu, then send data with this feature activated. If the bend values display with the overbend doubled, then you know that the control handles the springback compensation automatically.

Miscellaneous Changes

• Dashes and zeros for non-functioning values in the XYZ and LRA grids are now replaced with white spaces.
  
• The state of the Automatic Refresh Image checkbox in the Report page was not stored and recalled. Now it is.
  
• The image refresh for the report menu was changed to work better on slower computers.
  
• The installation allows for better control over how updates are performed.
  
  

Other

• Back to VTube-STEP
• Back to VTube Software Updates (for LASER Mode)
• Back to VTube-LASER