Reverse the Tube Ends

Back to VTube-STEP Back to VTube-LASER

Reverse the Tube Ends

It is often necessary to reverse the tube ends in order to bend the part from the other end of the tube. To reverse the tube ends, you can right click on the XYZ grids for the MASTER or MEASURED data and click on Reverse the Tube Ends.

About Supravision Files

Supravision files usually have a filename extension of $$$. They are text files that contain part setup, XYZ, and LRA data usually. They were used by Supravision software to save and load Supravision project files - so they contain a lot of data that VTube understands. (Supravision software was retired a few years ago by ROMER. It was one of the standards in the industry for decades.)

Other Pages

• Back to the VTube-STEP page
• Back to the VTube-LASER page