VTube-LASER Addata ZModem Communications Protocol

Addata ZModem Protocol Back to VTube-LASER Back to VTube Software Updates (for LASER Mode) Download in updates the VTube-LASER Support Page

About the Addata ZModem Communications Protocol

The Addata ZModem communications protocol is also known as the Addison "Non-Standard Device Interface". It allows for ZModem file transfer between VTube-LASER and any bender that complies with this protocol. (For example, the Arena Software bender controls.)

VTube-LASER allows you to setup the COM port configuration to match the configuration at the other end of the serial port connection. Enter System Options, click on the Measure 2 tab, then click on Benderlink. Set the protocol to Addata ZModem, and click on the COM port cell to display this COM port configuration dialog.

Video of RECALL and SEND

Click on the image at the right to see a RECALL/SEND with an Arena Control bender.