ROMER Certified Length Bar

ROMER Certified Length Bar Back to VTube-LASER

Recommended - But Not Standard

Certified length bars are good for verifying that your arm is working properly. The standard length bars use the 15mm calibration probe in one of three sockets. There are three lengths available: 305 mm 711 mm 1016 mm For most customers using a 2.5 meter arm, the recommended length bar to purchase is the 711 mm.

ROMER RDS Control Panel Probe Quick Check Feature

The ROMER RDS system allows you to easily perform a quick check for the arm with any probe installed. The procedure is inside the RDS Control Panel

600px

HEXAGON ACCESSORIES SITE

You can purchase new probes at the HEXAGON site.

Other Pages

• Back to VTube-LASER