VTube-LASER v2.9.9

Revision 2.9.9 Release Date: June 11, 2018 Current Build: 2 Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download updates the Support Page

NEW - SCP Feature (Stripe Cut Plane) - Eliminates LASER Stripe Data That Is Too Far From the Probe

The new STRIPE CUT PLANE feature is designed to eliminate entire laser stripes of data that are too far from the probe. It is included in the CUT PLANE CONTROL Window. This is helpful for smaller parts because the scanners have an active depth range that allows them to pick up stripes that are within a 127mm (5 inch) inch range top to bottom. The goal of the SCP feature is to ensure that the scanner does not accidentally catch any object in a stripe that is far away from the first diameter relative to the probe - even when it stops pickup up near data. (See the image on the right.) This is how SCP works with the other cut plane features: FIRST, the CUT PLANE feature removes any laser-scanned surface data found below standard cut planes that are active. SECOND, the DCP (DIAMETER CUT PLANE) feature removes the tails of laser-scanned stripes. THIRD, the SCP (STRIPE CUT PLANE) feature then removes any laser-scanned stripe that is too far from the probe relative to the closest stripe to the probe. Just like other cut plane features, the SCP feature is not used during tactile measurements with the ball probe.

FIX- Construct Tube Feature

A customer discovered that the Construct Tube feature was not working in the previous version due to changes in the measuring code. It is working in this version.

FIX- VTUBE-STEP MODE COLLECTION SELECTION ISSUE

We found issues with the collected objects in VTube-STEP mode. For example, the selected collected object (see the orange object) would never delete from the screen - even if the operator selected it and pressed delete. This issue could cause index errors in the Collection Features list memory displayed in the grid. The Collection Features Grid would not update automatically after a delete of the models on the screen. All of these issues have been fixed.

OTHER CHANGES

VTube-LASER will stop a Construct Tube process with ROMER arms if the LASER mode is active. It will now issue a warning to turn the LASER off.

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature