VTube-LASER Scan Score

VTube-LASER Scan Score Back to VTube-LASER Back to VTube-LASER Updates See also VTube-STEP Updates Download updates the Support Page

What is the VTube-LASER SCAN SCORE?

We've invented a way for users to score their last scan based on all historical data. The feature is called SCAN SCORE. This feature is available in VTube-LASER version 3, released in July of 2020. The Scan Score system is graded on a 100% scale. A score of 100% indicates that the scan was perfectly consistent with previous scans. Any score greater than 100% indicates that the cylinder scans were better than the historical average.

How the Scan Score is Calculated

All the Cylinder Fit values from each completed measure are stored in the project file and then used to create scores for each attribute on each straight. The Overall Scan Score is the average of all these cylinder fit scores for each Cylinder Fit qualification attribute over time. In the example on the right, the ovality measurement in the first straight was not quite as good as the historical average (80.5%). However, the Ovality score for the second straight was better than the average at 118.2%.

The Scan Score Protects Users from Poor Scans

As the historical list of Cylinder Fit values grows, the scan score becomes more helpful. If, for example, if your overall score on the last measure is 75%, then it is reasonable to conclude that something is wrong with the last tube measure - and you should rescan the tube before accepting the measured data as certain. In the 75% scan score example, we had to deform the last straight section with raised tape in order to achieve this low score. The last straight fails the qualification in this measure. The low scan score is an indicator that the measure is poor and should not be accepted until you remeasure.

Other Pages

• See VTube-LASER Addata ZModem Communications Protocol for more information.
• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature