TubeCAD Pro v8-20071002

User Selection of Prototype File Name for Either INCHES or MILLIMETERS

Prototype TubeCAD files are used to initialize the drawing setup to your preferences. This new feature will allow a TubeCAD user to quickly switch from one prototype file to another to switch default blockup, color, linetype, and unit information - just by selecting a new prototype TubeCAD file.

Before this new feature, the prototype files loaded were fixed to a single file for either INCHES or MILLIMETERS.

The TubeCAD Pro OPTIONS menu FILE TAB now allows you to enter or select a unique prototype file for either millimeters or inches.

A new set of radio buttons allows you to choose which one of the two default prototype files is used to clear TubeCAD Pro when it is started.

New Script Commands for the Command Engine

The NEW MILLIMETER or NEW INCH buttons in the TubeCAD toolbar (see below) now will use these internal filenames to call up the correct file. (The previous filenames were fixed.)

For example, the the blue-ball button above calls out to a script named "presetin.scr". A script is a series of keystrokes that TubeCAD Pro will perform when the script is run. The script takes advantage of the new commands

[options_prototype_in]

and

[options_prototype_mm]

in the command engine. These two tokens lookup the current default prototype drawing names (either mm or inches), then reset TubeCAD with these prototype file settings.

Here is the script code for presetin.scr:

multicmdopen
_openprototype
|
"[options_prototype_in]"
multicmdclose

Here is the script code for presetmm.scr:

multicmdopen
_openprototype
|
"[options_prototype_mm]"
multicmdclose