Benderlink Current Loop 4 Port - Measuring Center Side

Description

This is a four port module that was designed for connecting a Benderlink computer or measuring center computer up to four Eaton Leonard benders.

Installation Location

This module is typically placed near the Benderlink computer which acts as the measuring center side of the connection. The module can also be attached to any measuring center using Supravision software.

About the Connections

• RJ-45 ports - Ethernet cable converted to serial using RJ-45 to DB9 converters
• A four-port Quatech PCI board was installed in the Romer computer (Model: QS-PCI-100) The serial cables run from the RJ-45 ports on this module to the to the COM ports on the measuring center computer.
• The circular military connectors are connected to the Advanced Tubular current loop boards on the inside of the module. These ports are connected to the cables that run through the shop to the benders.

Inside the Module

This is an image of the inside of the module. It contains four of our current loop boards, one power supply, and all cabling.

Example Installation

This is an image of the box installed under the work-bench with a Romer arm and computer system.

Other Pages

Benderlink Current Loop Module page Benderlink page