Revision: Benderlink for Chiyoda/Keins 5.95
From ATTWiki
REPAIR - Bender Buttons Enable
The bender buttons would not RE-ENABLE after a send in or get in which the COM ports remained open. This has been resolved.
ENHANCE- Open Port Error Detection
Benderlink can leave ports open after communications occur. When a serial device server port is open, but is no longer available because of a disconnection over the network, Benderlink would show a severe error when none was really necessary. This has been changed so that the message displayed is that the bender is simply no longer online.
REPAIR - Images on Button in Data Target Menu
The images in this menu have been repaired so that they are centered in the buttons.
OTHER PAGES
- Back to Benderlink for KEINS
- Back to Benderlink for Chiyoda
- Benderlink for Chiyoda FAQ
- About Chiyoda - See this page for control version information.
