View source for End-Scan Using the End Wall

<table>
<tr cellpadding=10>
<td width=300>
[[image:vtube-laser_logo.jpg|300px]]
How to perform the end-wall end scan.<br><br>
* Back to [[VTube-LASER]]
</td>
<td width=300>
[[image:vtube-laser_1_73.jpg|300px]]
</td>
</tr>
</table>
__NOTOC__


===Why the End-Scan technique is important===

<table cellpadding=10>
<tr valign=top>
<td width=500>
This end-scan method is useful for increase in precision over the scissor method.
<br><br>
We recommend this for increased precision where high-reflectivity and burrs are not an issue on the end wall of the tube.
<br><br>
We also recommend the [[End-Scan Using the End Wall]] technique and the most precise [[End-Scan Using End Targets]].
</td>
<td width=300>
</td>
</tr>
</table>

===How To Use This End-Scan Technique===

<table cellpadding=10>
<tr valign=top>
<td width=300>
* Align the scanner at the end wall of the tube.<br><br>
*Press the green button until VTube-LASER is finished scanning all the end stripes.<br><br>
</td>
<td width=300>
[[image:EndWithEndWall1.jpg|300px]]
</td>
</tr>
</table>


===Another Way to Use This End-Scan Technique===


<table cellpadding=10>
<tr valign=top>
<td width=300>
* Align the scanner so that it touches one end wall of the tube.<br><br>
*Press the green button until VTube-LASER is finished scanning all the end stripes.<br><br>

The advantage of this method is that it is less prone to outlier points.  The disadvantage is that it is hard to aim at thinner walls.

</td>
<td width=300>
[[image:EndWithEndWall2.jpg|300px]]
</td>
</tr>
</table>

===Other Pages===

* Go to [[End-Scan Using the End Wall]]<br><br>
* Go to [[End-Scan Using End Targets]]<br><br>
* Back to [[VTube-LASER]]