View source for CNC Bender v12-20120830

<table>
<tr>
<td width=200>
==v12-20120830==
*Back to [[CNC Bender Software Updates]]
*To download the update see the [http://www.advancedtubular.com/customers/cncbender/page-downloads/version-12-20120830.html support page].
</td>
<td width=300>
[[image:cncv12procontrol_withteachmode.jpg|300px]]<br>
</td>
<td>
</td>
</tr>
</table>
__NOTOC__

=== [[image:Check.jpg|25px]] Enhanced: Autoloader Manual Page Redesign ===
CNC Bender can now make the TUBE ROTATE and SEAM DETECT buttons invisible.  See these two screens:<br>
[[image:v12-21020830_autoloader_manual_expanded.jpg|500px]]<br><br>
This next screen shows the two buttons removed from the screen:<br>
[[image:v12-21020830_autoloader_manual.jpg|500px]]<br><br>

<table cellpadding=10>
<tr valign=top>
<td width=500>
Control the visibility of buttons with new low level options:

[[image:v12-20120830_panelvisible_options.jpg|500px]]
</td>
<td width=300>
</td>
</tr>
</table>

===[[image:Check.jpg|25px]] NEW: Added new Processlists ===

<table cellpadding=10>
<tr valign=top>
<td width=400>
Three new process lists were added:

#autoloader_home.cncprocesslist
#autoloader_liftup.cncprocesslist
#autoloader_liftdown.cncprocesslist

<br><br>

These three processlists control the jogging that occurs behind the

*Autoloader Home button
*Lift Up button
*Lift Down button

<br><br>

Rules:
# The processlists do not need to exist - however, the buttons in the manual page will do nothing unless commands are inside the processlists.
# No block logic is accepted ([IF], etc.) in these processlists.
# Parameters are allowed - like "= cto:5000", etc.

</td>

<td width=300>
</td>
</tr>
</table>

=Other Pages=
*Back to [[CNC Bender]]
*Back to [[CNC Bender Software Updates]]
*See [[CNC Bender General Information]]
*See [[Teach Mode]]
*See [[Custom Command]]s