View source for CNC Bender v11-20090126

[[image:Cncbender_logo_pushbending.png]]
[[image:Operatorstation_model.jpg|right]]

__NOTOC__


===[[image:Check.jpg|25px]] NEW - SAVE and LOAD Tool Set Files from the Tool Page ===

The tool page now has load and save buttons for TOOL SET FILE management in CNC Bender.
<br><br>

[[image:cncbender_new_loadsave_file_toolpage.jpg|500px]]
<br><br>

===[[image:Check.jpg|25px]] ENHANCE - Adjust General Dynamic Option Name - Feed-Bend Torque Limits ===

The Low Level names of dynamic options "Feed Torque Safe High" and "Feed Torque Safe Low" were adjusted for clarification.
<br><br>
The new names include "Feed-Bend" inserted in the beginning to be sure users understand that these values are used by the Processlist Builder to limit the feed axis torque during Feed-Bending only.  '''''These values have no effect on the torque of the feed axis for any other type of feed motion.'''''
<br><br>
These are the options before the change:
<br><br>
[[image:cnc_torque_limit_options1.jpg]]
<br>
<br>
These are the options after the change:
<br><br>
[[image:cnc_torque_limit_options2.jpg]]
<br><br>
Upgrade Note: When upgrading to this version, it is important to remember to restore the dynamic options in low level in order to see this change take effect.
<br><br>

=== WARNING: Be Careful to Set Proper Torque Limits ===
<br>

<table cellpadding="15">
<tr><td width=25></td>
<td width=300 bgcolor="#f0f0f0">
<font size=5>[[image:Gear_warning.jpg]] <b>WARNING!</b><br><br></font>
<font size=3>'''Do not''' set the HIGH value to any value above the recommended value - or the Feed Axis gear box or other parts of the carriage or carriage motion system could be damaged by high settings in the Bender Data page.<br><br>
"25%" is typically the maximum recommended value for extended-run.<br><br>
Any higher value may damage the machine and possibly void the warranty.
</font></td></tr></table>


<table cellpadding="15">
<tr><td width=25></td>
<td width=300 bgcolor="#f0f0f0">
<font size=5>[[image:Gear_warning.jpg]] <b>WARNING!</b><br><br></font>
<font size=3>'''Do not''' set the LOW value to any value below the recommended value - or the Feed Axis gear box or other parts may run-away due to high-errors.<br><br>
"10%" is typically the minimum recommended value for extended-run.<br><br>
Any lower value may damage the machine and possibly void the warranty.
</font></td></tr></table>

=Other Pages=
*Back to [[CNC Bender]]
*Back to [[CNC Bender Software Updates]]
*Read about [[Push Bending]]
*Read about [[Push Bend Profile Table]]s