Difference between revisions of "USB Network Interfaces"
From ATTWiki
(→October 2008 Note) |
|||
| (9 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| − | <table cellpadding=" | + | <table cellpadding="25"> |
| − | <tr><td width= | + | <tr><td width=20></td> |
<td width=300 bgcolor="#f0f0f0"> | <td width=300 bgcolor="#f0f0f0"> | ||
<font size=5>[[image:Gear_warning.jpg]] <b>WARNING</b><br><br></font> | <font size=5>[[image:Gear_warning.jpg]] <b>WARNING</b><br><br></font> | ||
| − | <font size=3>USB-based network | + | <font size=3>USB-based network solutions are recommended for use on CNC Bender operator stations only when there is no other choice of adaptors.</font></td></tr></table> |
| − | + | Some (not all) USB-based networking often takes too many resources from the CNC Bender CPU and the PC Panel. | |
<br><br> | <br><br> | ||
| − | USB | + | If you can avoid it, we do not recommend that you install a USB network driver or USB network adapter. |
| + | |||
| + | <br><br> | ||
| + | |||
| + | ==October 2008 Note== | ||
| + | |||
| + | We've had good success with the TrendNet device on Win2000 operator stations that have no available NIC ports:<br> | ||
| + | [[image:trendnet_usb_network.jpg]] | ||
Latest revision as of 03:25, 10 October 2008
|
|
Some (not all) USB-based networking often takes too many resources from the CNC Bender CPU and the PC Panel.
If you can avoid it, we do not recommend that you install a USB network driver or USB network adapter.
October 2008 Note
We've had good success with the TrendNet device on Win2000 operator stations that have no available NIC ports:
