Difference between revisions of "CNC Bender v11-20091218"
From ATTWiki
Line 53: | Line 53: | ||
* As of version [[CNC Bender v11-20091104]], CNC Processlist Builder inserts a new [BEGIN RUN AGAIN] label placed in the middle of each part's process list to trim off processing time. This allows CNC Processor to skip the initialization section of each new part after it has been run once.<br><br> | * As of version [[CNC Bender v11-20091104]], CNC Processlist Builder inserts a new [BEGIN RUN AGAIN] label placed in the middle of each part's process list to trim off processing time. This allows CNC Processor to skip the initialization section of each new part after it has been run once.<br><br> | ||
− | * We discovered that the switch to the [BEGIN RUN AGAIN] label did not occur until after the second time through the processlist. This increased time slightly, and sometimes caused the bend arm to pause on the way to the home position when the '''"Last Row Absolute Feed Clear - Immediate Move"''' was ENABLED.<br><br> | + | * We discovered that the switch to the [BEGIN RUN AGAIN] label did not occur until after the '''second time''' through the processlist. This increased time slightly, and sometimes caused the bend arm to pause on the way to the home position when the '''"Last Row Absolute Feed Clear - Immediate Move"''' was ENABLED.<br><br> |
</td> | </td> |
Revision as of 18:35, 19 December 2009
|
REPAIR - Feed Accuracy Fix During Feed/Rotate Motion When Bend Arm Returning
|
OPTIMIZATION - for [BEGIN RUN AGAIN]
|
NEW - Second Constant Run List Designed for HIGH SPEED OPERATIONS
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Absolute Rotate
- See Absolute Rotate Offset Position
- See Final Feed Clearance
- See Mandrel Retract
- See Mandrel Retract Part Release