Difference between revisions of "Cable Spec 35"
From ATTWiki
| Line 28: | Line 28: | ||
<td> | <td> | ||
| + | <!--- Left table in table for RJ45 pins --> | ||
<table> | <table> | ||
| Line 85: | Line 86: | ||
<table> | <table> | ||
<tr> | <tr> | ||
| − | <td width= | + | <td width=50 align=left> |
2 | 2 | ||
</td> | </td> | ||
| − | <td width= | + | <td width=150 align=left> |
RXD | RXD | ||
</td> | </td> | ||
| Line 94: | Line 95: | ||
<tr> | <tr> | ||
| − | <td width= | + | <td width=50 align=left> |
3 | 3 | ||
</td> | </td> | ||
| − | <td width= | + | <td width=150 align=left> |
TXD | TXD | ||
</td> | </td> | ||
| Line 103: | Line 104: | ||
<tr> | <tr> | ||
| − | <td width= | + | <td width=50 align=left> |
5 | 5 | ||
</td> | </td> | ||
| − | <td width= | + | <td width=150 align=left> |
GND | GND | ||
</td> | </td> | ||
| Line 112: | Line 113: | ||
<tr> | <tr> | ||
| − | <td width= | + | <td width=50 align=left> |
7 | 7 | ||
</td> | </td> | ||
| − | <td width= | + | <td width=150 align=left> |
RTS | RTS | ||
</td> | </td> | ||
| Line 121: | Line 122: | ||
<tr> | <tr> | ||
| − | <td width= | + | <td width=50 align=left> |
8 | 8 | ||
</td> | </td> | ||
| − | <td width= | + | <td width=150 align=left> |
CTS | CTS | ||
</td> | </td> | ||
</tr> | </tr> | ||
| − | |||
</table> | </table> | ||
Revision as of 14:19, 23 May 2012
|
This is the wiring schematic for the RJ45 to DB9 female adapter for the CB-EL1 RS232D port on the board. |
|
RJ45 Plug Side |
|
DB9 Female Side |
||||||||||||||||||||
|
|
|
|
This is an image of an RJ45 to DB9 adapter with the above wiring. The DB9 port is female to attach to a standard PC male port. |
|
|
|
