Difference between revisions of "Cable Spec 21"
From ATTWiki
(→Notes) |
|||
| Line 29: | Line 29: | ||
===Notes=== | ===Notes=== | ||
| − | * The wire colors can vary from the diagram shown above. It is only important that the wires are connected to the correct points.<br><br | + | * The wire colors can vary from the diagram shown above. It is only important that the wires are connected to the correct points.<br><br> |
* The wire in A1 is not required for this bender. Some cables will not include that wire.<br><br> | * The wire in A1 is not required for this bender. Some cables will not include that wire.<br><br> | ||
| − | * The wire going into B3 is the wire that indicates if the bender is ON or OFF. Pin B3 outputs between 5 and 10 volts DC. If the | + | * The wire going into B3 is the wire that indicates if the bender is ON or OFF. Pin B3 outputs between 5 and 10 volts DC. If the bender control is ON, then the DSR signal at the Benderlink computer's COM port will show ACTIVE. |
| − | + | ||
==Other Pages== | ==Other Pages== | ||
* Back to [[Cable Spec]]s | * Back to [[Cable Spec]]s | ||
Revision as of 21:42, 21 October 2016
|
|
|
|
|
Notes
- The wire colors can vary from the diagram shown above. It is only important that the wires are connected to the correct points.
- The wire in A1 is not required for this bender. Some cables will not include that wire.
- The wire going into B3 is the wire that indicates if the bender is ON or OFF. Pin B3 outputs between 5 and 10 volts DC. If the bender control is ON, then the DSR signal at the Benderlink computer's COM port will show ACTIVE.
Other Pages
- Back to Cable Specs
