Difference between revisions of "VTube-LASER v2.8"
From ATTWiki
(→25px NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values) |
(→25px NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values) |
||
| Line 52: | Line 52: | ||
The report template source to create this table is shown below:<br><br> | The report template source to create this table is shown below:<br><br> | ||
[[image:vtl-2.8_inspection data tangent average and maximum html sample.png|300px]] | [[image:vtl-2.8_inspection data tangent average and maximum html sample.png|300px]] | ||
| + | |||
| + | <br><br> | ||
| + | The new commands are '''"array_dev_tmt_average"''' and '''"array_dev_tmt_maximum"'''. | ||
<td> | <td> | ||
Revision as of 14:26, 16 February 2017
|
Revision 2.8Release Date: Not Released
|
|
Contents |
BUILD 11 - February 15, 2017
NEW: "Default Tolerance Ends" Value
|
The Default Tolerance Ends value is in the Inspection Data menu.
|
|
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
|
Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation.
The report template source to create this table is shown below:
|
|
Other Changes
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See VTube-LASER Cut Planes
- See the tutorial on DCP - Diameter Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
