Revision 2.8

Release Date: Not Released

• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)

The Default Tolerance Ends value is in the Inspection Data menu.

It allows you to set the end length default values separately from the tangent point / midpoint tolerance values.

Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation.

The new commands are

• array_dev_tmt_average
  
• array_dev_tmt_maximum

See the example result in the report on the right, and the report template source to create this table shown below.

The process for corrections to Winton WMC files were clarified with dialogs that make it very clear what VTube-LASER Bender Setup is doing during the Winton WMC correction process.

Steps 2 and 5 are new. They carefully explain what is happening during the correction process.

Step 5 also explains that a BACKUP file is created during the process. This allows operators to always get back to the previous data if something goes wrong in the correction process.

New Dialogs During Correction:

Overall Corrections Process:

Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation.

The new commands are

• array_dev_tmt_average
  
• array_dev_tmt_maximum

See the example result in the report on the right, and the report template source to create this table shown below.