Difference between revisions of "VTube-LASER v2.8"
(→NEW DIALOGS) |
(→NEW BACKUP) |
||
| Line 80: | Line 80: | ||
Steps 2 and 5 are new. They carefully explain what is happening during the correction process.<br><br> | Steps 2 and 5 are new. They carefully explain what is happening during the correction process.<br><br> | ||
| − | ===NEW BACKUP=== | + | ===NEW BACKUP CREATED=== |
Step 5 also explains that a BACKUP file is created during the process. This allows operators to always recover to the previous data if something goes wrong in the correction process. (The creation of a backup file is new in this version.) | Step 5 also explains that a BACKUP file is created during the process. This allows operators to always recover to the previous data if something goes wrong in the correction process. (The creation of a backup file is new in this version.) | ||
<br><br> | <br><br> | ||
Revision as of 01:12, 4 March 2017
|
Revision 2.8Release Date: Not Released
|
|
Contents |
BUILD 11 - February 15, 2017
NEW: "Default Tolerance Ends" Value
|
The Default Tolerance Ends value is in the Inspection Data menu.
|
|
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
|
Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation.
|
|
BUILD 19 - February 22, 2017
ENHANCED: Winton WMC Communications Improvement
|
The process for corrections to Winton WMC files were clarified with dialogs that make it very clear what VTube-LASER Bender Setup is doing during the Winton WMC correction process.
NEW HELP DIALOGSSteps 2 and 5 are new. They carefully explain what is happening during the correction process. NEW BACKUP CREATEDStep 5 also explains that a BACKUP file is created during the process. This allows operators to always recover to the previous data if something goes wrong in the correction process. (The creation of a backup file is new in this version.)
|
Immediately after the user presses the Auto Correction button, this dialog appears (see step 2 below): Immediately after the user presses the Exit and Save setup data button, this dialog appears (see step 4 below): Overall Corrections Process: |
NEW: REPORT COMMANDS - Tangent Deviation AVERAGE and MAXIMUM Values
|
Two new array values are available for reports: AVERAGE deviation and MAXIMUM deviation.
|
|
Other Pages
- Back to VTube-LASER
- Back to VTube Software Updates (for LASER Mode)
- See also VTube-STEP
- See also VTube-STEP Revisions
- See VTube-LASER Customer Support Page to download the latest version.
- See VTube-LASER Cut Planes
- See the tutorial on DCP - Diameter Cut Planes
- See How to Measure Tubes Attached to an Evaporator with the DCP Feature
