Difference between revisions of "How to Install a CNC Bender Upgrade"

Revision as of 19:43, 8 October 2007

SELF-INSTALL a CNC BENDER UPGRADE following these steps

STEP 1
Download the setup file from the revision page. See CNC Bender Software Updates for a list of revision pages.

STEP 5
Close the CNC Bender Loader when it reappears. The newer non-button versions of this loader will unload if you right-click on them.

STEP 6
Plug the USB drive into a USB port on the CNC Bender operator station. The older systems have USB ports inside the operator station. Some have USB ports installed on the enclosure. Newer Magelis controls feature a USB port on the front of the PC Panel bezel.

STEP 7
Run the setup program. You will need to enter the password to install the software.

STEP 8
When the setup program is complete, remove the USB drive using the safe removal procedure. (See Safely Remove a USB Drive)

STEP 9
Run the CNC Bender Loader by finding it in your START/All Programs/Startup menu.

@@ Line 17: / Line 17: @@
 *STEP 6<br>Plug the USB drive into a USB port on the CNC Bender operator station.  The older systems have USB ports inside the operator station.  Some have USB ports installed on the enclosure.  Newer Magelis controls feature a USB port on the front of the PC Panel bezel.
 <br>
-*STEP 7<br>Run the setup program
+*STEP 7<br>Run the setup program.  You will need to enter the password to install the software.
 [[image:Cncbender_setup_dialog.png]]<br>