Difference between revisions of "CNC Bender v11-20090120"
From ATTWiki
| Line 18: | Line 18: | ||
[SECONDARY_PROCLIST] button_chuckclose, enable, reset | [SECONDARY_PROCLIST] button_chuckclose, enable, reset | ||
</pre> | </pre> | ||
| − | + | <br> | |
| − | + | ||
| − | + | ||
This new feature allows CNC Bender to always reset secondary process lists from the beginning. | This new feature allows CNC Bender to always reset secondary process lists from the beginning. | ||
<br><br> | <br><br> | ||
Revision as of 12:14, 21 January 2009
NEW - Multitask Process List Features
CNC Bender now includes the capability of starting multi-tasking process lists in either RESET or CONTINUE mode.
RESET is the new default if no parameter is supplied.
An example for starting a secondary processes is shown here. The new "reset" parameter is at the end of the line following the ENABLE command:
[SECONDARY_PROCLIST] button_chuckclose, enable, reset
This new feature allows CNC Bender to always reset secondary process lists from the beginning.
The RESET command solves issues that may crop up when starting a secondary process inadvertently in the middle of the list. For example, if the process list is running in CONTINUE mode (the old default), then the process could accidentally automatically close the chuck at the beginning of a new cycle.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables
