Difference between revisions of "Revision: Benderlink for BLM 5.3"
(→25px NEW - Large Green LED to Show Measuring Center Monitoring) |
(→25px NEW - Large Green LED to Show Measuring Center Monitoring) |
||
| Line 31: | Line 31: | ||
<td width=400> | <td width=400> | ||
[[image:benderlinkblm_v5.3_large_led.png|400px]] | [[image:benderlinkblm_v5.3_large_led.png|400px]] | ||
| + | </td> | ||
| + | </tr> | ||
| + | |||
| + | </table> | ||
| + | <br><br> | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | ===[[image:Check.jpg|25px]] NEW - Do Not Allow Measuring Center to Change End Lengths=== | ||
| + | <table width=700> | ||
| + | |||
| + | <tr> | ||
| + | <td width=300> | ||
| + | During CORRECTION of parts with extra material on the ends, it is helpful to not allow the end lengths to change. This keeps the carriage in approximately the same start position.<br><br> | ||
| + | </td> | ||
| + | <td width=400> | ||
| + | [[image:blinkblm_donotallowmeasuringcenterchangeendlengths.png|400px]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
Revision as of 21:49, 14 October 2015
|
Revision 5.3
|
|
- See Benderlink for BLM Customer Support Page to download the latest version.
NEW - Large Green LED to Show Measuring Center Monitoring
|
A new larger green LED port indicator to show that Benderlink is monitoring for measuring center communications is added to the interface. |
|
NEW - Do Not Allow Measuring Center to Change End Lengths
|
During CORRECTION of parts with extra material on the ends, it is helpful to not allow the end lengths to change. This keeps the carriage in approximately the same start position. |
|
ENHANCED - The Communications Protocol is Enhanced for LASERVISION Windows Version
|
The internal communications logic was enhanced to work properly with Windows versions of LASERVISION. (It already worked with DOS versions of LASERVISION.) |
|
NEW - Click on LEDs to Toggle to Measuring Center Monitoring
|
You can now click on either LED indicator to toggle monitoring for the measuring center commmands. |
|
FIXED - Ping Port Confirmation Works in Newer Windows
|
This feature allows Benderlink to ping for a serial device server before opening a virtual port. |
|
NEW - Message Warning for Ports That Cannot Open
|
When a port to the measuring center cannot open, Benderlink now displays a message that a problem occurred. |
|
Other Pages
- Back to Benderlink for BLM Revisions
- Back to Benderlink for BLM
- Back to Benderlink
- Go to the main website Benderlink for BLM page
- About BLM Group USA
