Difference between revisions of "Cable Spec 21"

From ATTWiki
Jump to: navigation, search
(→‎Notes)
Line 25: Line 25:
 
</table>
 
</table>
  
−
[[image:cablespec21_pinout.png]] <br><br>
+
[[image:cablespec21_pinout.png]]
  
  

Revision as of 21:42, 21 October 2016

  • This is the wiring schematic for Cable Spec 21 used in MQ85 benders.
  • This is a 15 foot cable.
  • Use yellow sheath if possible.
  • Use twisted pair Ethernet. Never use solid core cable.

Cablespec21 cableimage.png

Ampmod 20pin cable21.png

Cablespec21 ampmod cableside.png

Cablespec21 pinout.png


Notes

  • The wire colors can vary from the diagram shown above. It is only important that the wires are connected to the correct points.

  • The wire in A1 is not required for this bender. Some cables will not include that wire.

  • The wire going into B3 is the wire that indicates if the bender is ON or OFF. Pin B3 outputs between 5 and 10 volts DC. If the bender control is ON, then the DSR signal at the Benderlink computer's COM port will show ACTIVE.

Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=Cable_Spec_21&oldid=31756"