Difference between revisions of "CNC Bender v10-20070920"
From ATTWiki
(→Explanation of Issue) |
|||
| Line 15: | Line 15: | ||
<ul> | <ul> | ||
| − | ==Explanation of | + | ==Explanation of Potential Problem== |
* CNC Bender software saves its current state and setup in a configuration files and registry entries software during shutdown. | * CNC Bender software saves its current state and setup in a configuration files and registry entries software during shutdown. | ||
| Line 24: | Line 24: | ||
[[image:V10_20070828_radius_options.jpg|450px]] | [[image:V10_20070828_radius_options.jpg|450px]] | ||
| − | |||
==Solution To Issue== | ==Solution To Issue== | ||
Revision as of 20:10, 20 September 2007
Contents |
REVISION Information
10-20070920, September 20, 2007
ENHANCED: Improved and Safer Shutdown
- CNC Bender software saves its current state and setup in a configuration files and registry entries software during shutdown.
- If the standard shutdown procedure is bypassed due to a loss of power or a system crash, then CNC Bender, in previous versions, may attempt to write a file - only to be interrupted in the shutdown task.
- The result is a possible corruption of this file.
- The operator requests shutdown of software.
- CNC Bender hides the interface.
- CNC Bender displays a shutdown message on the screen showing a progress bar.
- After the progress bar is filled, CNC Bender saves its configuration data.
Explanation of Potential Problem
Solution To Issue
This version solves the problem by placing an intentional delay between the time the operator requests a shutdown and the time the configuration data is written to disk and registry.
So...
If the power is removed or the system crashes
[DISPLAY] Next Step: (FRB Row 2) Move Feed Axis +1.0000 IN Relative FeedPositive = pos0:25.40000000, vel0:694.00000000, ump0:1, cto:60000
{any other commands}
[SECONDARY_PROCLIST] radius_shift_part11, enable
