Difference between revisions of "How to Install a CNC Bender Upgrade"
| Line 1: | Line 1: | ||
| + | SELF-INSTALL a CNC BENDER UPGRADE following these steps | ||
| + | ==STEP 1== | ||
| + | Download the setup file from the revision page. | ||
| − | + | ==STEP 2== | |
| − | + | Get a password from Advanced Tubular for unlocking the setup file. | |
| − | + | ||
| − | + | ==STEP 3== | |
| + | Copy the setup program to a USB flash drive. | ||
| + | |||
| + | ==STEP 4== | ||
| + | Close CNC Bender software. | ||
| + | |||
| + | ==STEP 5== | ||
| + | Close the [[CNC Bender Loader]] when it reappears. The newer non-button versions of this loader will unload if you right-click on them. | ||
| + | |||
| + | ==STEP 6== | ||
| + | Plug the USB drive into a USB port on the CNC Bender operator station. The older systems have USB ports inside the operator station. Some have USB ports installed on the enclosure. Newer Magelis controls feature a USB port on the front of the PC Panel bezel. | ||
| + | |||
| + | ==STEP 7== | ||
| + | Run the setup program | ||
| + | |||
| + | ==STEP 8== | ||
| + | When the setup program is complete, remove the USB drive using the safe removal procedure. (See [[Safely Remove a USB Drive]] | ||
| + | |||
| + | ==STEP 9== | ||
| + | Run the CNC Bender Loader by finding it in your START/All Programs/Startup menu. | ||
| + | |||
| + | ==STEP 10== | ||
| + | Run CNC Bender by pressing on the Loader | ||
Revision as of 18:51, 8 October 2007
SELF-INSTALL a CNC BENDER UPGRADE following these steps
Contents |
STEP 1
Download the setup file from the revision page.
STEP 2
Get a password from Advanced Tubular for unlocking the setup file.
STEP 3
Copy the setup program to a USB flash drive.
STEP 4
Close CNC Bender software.
STEP 5
Close the CNC Bender Loader when it reappears. The newer non-button versions of this loader will unload if you right-click on them.
STEP 6
Plug the USB drive into a USB port on the CNC Bender operator station. The older systems have USB ports inside the operator station. Some have USB ports installed on the enclosure. Newer Magelis controls feature a USB port on the front of the PC Panel bezel.
STEP 7
Run the setup program
STEP 8
When the setup program is complete, remove the USB drive using the safe removal procedure. (See Safely Remove a USB Drive
STEP 9
Run the CNC Bender Loader by finding it in your START/All Programs/Startup menu.
STEP 10
Run CNC Bender by pressing on the Loader
