Difference between revisions of "How to Install a CNC Bender Upgrade"

Revision as of 19:03, 8 October 2007

SELF-INSTALL a CNC BENDER UPGRADE following these steps

STEP 5
Close the CNC Bender Loader when it reappears. The newer non-button versions of this loader will unload if you right-click on them.

STEP 6
Plug the USB drive into a USB port on the CNC Bender operator station. The older systems have USB ports inside the operator station. Some have USB ports installed on the enclosure. Newer Magelis controls feature a USB port on the front of the PC Panel bezel.

STEP 8
When the setup program is complete, remove the USB drive using the safe removal procedure. (See Safely Remove a USB Drive)

STEP 9
Run the CNC Bender Loader by finding it in your START/All Programs/Startup menu.

@@ Line 13: / Line 13: @@
 *STEP 5<br>Close the [[CNC Bender Loader]] when it reappears.  The newer non-button versions of this loader will unload if you right-click on them.
 <br>
-[[image:Cncbender_loader_software.jpg|400px]]
+[[image:Cncbender_loader_software.jpg|400px]]<br>
 *STEP 6<br>Plug the USB drive into a USB port on the CNC Bender operator station.  The older systems have USB ports inside the operator station.  Some have USB ports installed on the enclosure.  Newer Magelis controls feature a USB port on the front of the PC Panel bezel.
 <br>