Cable Spec 21

This is the wiring schematic for Cable Spec 21 used in MQ85 benders. This is a 15 foot cable. Use yellow sheath if possible. Use twisted pair Ethernet. Never use solid core cable.

Notes

• The wire colors can vary from the diagram shown above. It is only important that the wires are connected to the correct points.
  <br
• The wire in A1 is not required for this bender. Some cables will not include that wire.
  
  
• The wire going into B3 is the wire that indicates if the bender is ON or OFF. Pin B3 outputs between 5 and 10 volts DC. If the signal for this pin is ON, then the DCD signal at the Benderlink computer will show ACTIVE.

Other Pages

• Back to Cable Specs