Cable Spec 21

From ATTWiki
Revision as of 21:45, 21 October 2016 by Mcone (Talk | contribs)

Jump to: navigation, search
  • This is the wiring schematic for Cable Spec 21 used in MQ85 benders.
  • This is a 15 foot cable.
  • Use yellow sheath if possible.
  • Use twisted pair Ethernet. Never use solid core cable.

Cablespec21 cableimage.png

Ampmod 20pin cable21.png

Cablespec21 ampmod cableside.png

Cablespec21 pinout.png


Notes

  • The wire colors can vary from the diagram shown above. It is only important that the wires are connected to the correct points.

  • The A row in the Amp Mod U block (the black rectangular connector) is always on the KEY side of the connector.

  • Pin 1 is indicated with an arrow embedded in the plastic of the Amp Mod U block.

  • A wire in A1 is not required for this bender. Some cables will not include that wire.

  • The wire going into B3 is the wire that indicates if the bender is ON or OFF. Pin B3 outputs between 5 and 10 volts DC. If the bender control is ON, then the DSR signal at the Benderlink computer's COM port will show ACTIVE.

Other Pages

Retrieved from "http://www.advancedtubular.wiki/index.php?title=Cable_Spec_21&oldid=31758"