View source for CNC Bender v10-20070726b

[[image:Cncbender.jpg|thumb|CNC Bender User Interface for ProControl]]


__TOC__


=REVISION Information=

10-20070726, July 26, 2007
<br>
<br>
<br>

=FIXED: BeyondLastCycleTime Variable=

===About===
The BeyondLastCycleTime variable used in the Constant Run Processlist is designed to allow CNC Bender to take action if the the bender is a certain time beyond the last cycle time.  A CYCLE is considered any JOG, STEP, or AUTO mode action.


Example code from Constant Run Processlist:

<pre>
[if] and, BeyondPowerOnTime=2000, BeyondLastCycleTime=300000, BeyondLastCycleTime=not(301000)
  [display]AUTOMATIC PRESSURE Off After 5 Minutes 
  HydraulicPressureAllOFF
[end]
</pre>

===Repair===
This variable was not being updated properly in the STEP or AUTO modes.  In versions v10-2007vvvv of CNC Bender, the benders would shutdown in the middle of bending after a five minute period because it believed that the bender was idle (which it was not).

This has been repaired.

<br>
<br>
<br>

=FIXED: RECAPTURE=

===About===
Recapture allows CNC Bender to recapture a part with the chuck after having previously release it.

===Repair===
Compiling a processlist with recapture to memory create a compilation error that stopped the transfer of data into CNC Processor.

This has been resolved.


<br>
<br>
<br>

=First Installed To Benders=

*SMT 12652 - VB150 - Triple Radius Head Shifter
*SMT 15687 - VB150 - Triple Radius Head Shifter
*SMT 15688 - VB150 - Double Radius Head Shifter

--[[User:Mcone|Mcone]] 14:59, 3 August 2007 (EDT)