View source for Configuring Machine Lube Settings

The CNC Processor configuration file contains the values necessary to adjust the machine lube settings.

==Where to find it in CNC Bender==
The configuration is displayed in an editor in the Low Level menu, CNC Processor CFG tab.<br>
<br>
[[image:cncbender_cncprocessor_config_file.jpg|400px]]

==Where to find it on the Hard Disk==
The file is available in the c:\cnc\config folder in the file "CNCProcessor.cfg".

=="Machine Lube" Section==
The settings in this file are separated by sections with section names in square brackets like this:

<pre>
[Machine Lube]
Machine Lube Duration=5000
Lube Machine At Bend Count=100
Pulse Machine Lube Pump=1
Watch For Machine Lube Complete Input=0
</pre>

The four values above control the machine lube features in CNC Bender.

Read details for each of the values here:

* [[Machine Lube Duration]]
* [[Lube Machine At Bend Count]]
* [[Pulse Machine Lube Pumpt]]
* [[Watch For Machine Lube Complete Input]]

==Other Pages==
Back to