View source for About VTube-LASER End Angle Qualification

<table>
<tr cellpadding=10>
<td width=225>
[[image:vtube-laser_logo_1.96.png|300px]]


==About VTube-LASER End Engle Qualifications==



</td>
<td width=300>
[[image:vtube-laser_v2.7_screenshot.png|400px]]
</td>
</tr>
</table>



==End Angle Qualification==
<table cellpadding=10 width=900>

<tr valign=top>
<td width=300>
The end angle deviation is the total angle the measured centerline end length varies from the master end length in degrees.<br><br>
VTube-LASER includes end-angle qualifications because GMC used to include +/- 1 degree for the end-length qualification.<br><br>
However, it is our opinion that this qualification is redundant because the end lengths are already qualified in the tangent-midpoint-tangent grid. In general, it is better to qualify a tube shape using linear units than polar (angular) units.</td>
<td>
[[image:EndAngleDeviations.png|500px]]
</td>

</tr>

</table>
<br><br>

==Other Pages==

*Back to [[VTube-LASER]]