View source for CNC Bender v12-20101021

<table>
<tr>
<td width=300>
[[image:cncv12procontrol_withteachmode.jpg|300px]]<br>
</td>
<td>
</td>
</tr>
</table>

__TOC__
<br>

===[[image:Check.jpg|25px]] NEW - Added Input Timer in PreEnable Processlist  ===

<table cellpadding=10>
<tr valign=top>
<td width=200>
Schneider Lexium drives require a pulse to switch from READY to RUN mode.  <br><br>

Input TIMERS are now allowed in the PreEnable processlist to pulse the Lexium drives with an output point for a specific amount of time before the axes were enabled.<br><br>
</td>
<td>
[[image:lexium_drive_motor.jpg]]
</td>
</tr>

</table>

===[[image:Check.jpg|25px]] FIXED - Early Mandrel Extract On Last Bend  ===

<table cellpadding=10>
<tr valign=top>
<td width=200>
For benders with motion-controlled [[PDA]] - the early mandrel extract now works.<br><br>
(Image courtesy of [http://www.toolsforbending.com/mandrels.asp Tools For Bending web site])
</td>
<td>
[[image:ball_mandrel.jpg]]<br>
</td>
</tr>


</table>

===[[image:Check.jpg|25px]] CHANGED- KEYBOARD HANDLING  ===

<table cellpadding=10>
<tr valign=top>
<td width=200>
The keyboard features were completely locked out of previous main-window user interfaces to prevent a problem with accidental motion in the MANUAL page.  This was too drastic and restrictive for operators that wanted to use the keyboard.
<br><br>
Now the keyboard works in every part of the user interface except with the manual buttons that can cause motion.  Manual buttons will not receive any keyboard input.
</td>
<td>
[[image:keyboard.jpg|150px]]
</td>
</tr>


</table>

=Other Pages=
*Back to [[CNC Bender]]
*Back to [[CNC Bender Software Updates]]
*See [[CNC Bender General Information]]
*See [[Teach Mode]]
*See [[Custom Command]]s