Difference between revisions of "Benderlink for KEINS"

Revision as of 13:52, 2 March 2009

This software is designed to communicate with Chiyoda and KEINS benders.

Feature	Description
1	It allows for intelligent bi-directional communications with measuring centers.
2	It allows for true DNC offline programming. This means that you can control every setup parameter from Benderlink (Note: All operator accessible parameters are programmable. The low level passworded machine parameters that control the personality of the bender are not programmable by Benderlink.)
3	It allows customers to use a PC disk / network to store all Chiyoda / KEINS parts off the control. (Bypassing the floppy drive.)

Communicate	Communicate and manage files for up to 99 benders.
Edit Bender Data	Edit bender data in Windows
Corrections Loops	CORRECTIONS LOOPS with measuring centers.
OFFLINE	The Benderlink offline license allows engineers to program Benderlink from a location that are off-site or at a remote location. The only difference between the OFFLINE license and the FULL license is that the OFFLINE version of the software will not communicate with benders. Typically offline license is used to save the data files to a shared network location. The full version of Benderlink that is connected to the bender can load the files created and saved with the offline version of Benderlink.

See the PDF data sheet section below for details.

	Download a Datasheet for Benderlink for KEINS Download a Datasheet for Benderlink Ethernet Module for KEINS
	Download a DataSheet that explains the License Levels in Benderlink for Chiyoda/KEINS.

@@ Line 27: / Line 27: @@
 <br>
-== LICENSE TYPES ==
+== FEATURE DETAILS ==
-There are four license types.  Each of these license levels allow you to custom-tailor your purchase with your application.
 <table cellspacing=15>
 <tr>
-<td width=150 bgcolor="#e3e4f5">FULL Level 1</td>
+<td width=150 bgcolor="#e3e4f5">Communicate</td>
 <td>Communicate and manage files for up to 99 benders.</td>
 </tr>
 <tr>
-<td bgcolor="#e3e4f5">FULL Level 2</td>
+<td bgcolor="#e3e4f5">Edit Bender Data </td>
-<td>Level 1 PLUS Edit bender data in Windows</td>
+<td>Edit bender data in Windows</td>
 </tr>
 <tr>
-<td bgcolor="#e3e4f5">FULL Level 3</td>
+<td bgcolor="#e3e4f5">Corrections Loops</td>
-<td>Levels 1 and 2 PLUS enable CORRECTIONS LOOPS with measuring centers.</td>
+<td>CORRECTIONS LOOPS with measuring centers.</td>
 </tr>
 <tr>