Difference between revisions of "Benderlink for Pines"
From ATTWiki
(→Version 1.0 (Obsolete)) |
|||
| Line 44: | Line 44: | ||
|} | |} | ||
| − | =Version 1.0 ( | + | =Version 1.0 (Retired)= |
{| border="0" cellpadding="5" cellspacing="0" align="none" width=700 | {| border="0" cellpadding="5" cellspacing="0" align="none" width=700 | ||
| Line 53: | Line 53: | ||
| [[image:Blinkpines_v1_mainscreen.jpg|400px]] | | [[image:Blinkpines_v1_mainscreen.jpg|400px]] | ||
|} | |} | ||
| − | |||
=Version Updates= | =Version Updates= | ||
Revision as of 02:07, 9 June 2009
Contents |
About
| Benderlink for Pines is software that connects PINES TS-2000 controls with Eaton Leonard Vector Laservision measuring centers. It essentially makes a TS-2000 control appear to be an Eaton Leonard PREMIER control to a Vector Laservision measuring center. |
|
TS-2000 Control to Vector 1 Laservision
|
The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines. The protocol used is the Velog/El-2000/Premier protocol - so the software is compatible with Eaton Leonard Vector Laservision out of the box. |
|
Benderlink Ethernet Module for PINES
| The software uses the Benderlink Ethernet Module for PINES to Vector to connect to any Vector. | 
|
Version 2.0 - Plug-And-Play Compatible with Vector Laservision
| Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center.
|
|
Version 1.0 (Retired)
| Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision. Eaton Leonard referred to this as a "Competitive Bender Interface" because it was designed to grant competitors the right to use the measuring center through license charges.
|
|
Version Updates
| Screen Shot | Date Released | Link to Page | New Features |
|
April 28, 2008 | Benderlink for Pines 2.0 |
|
Other Pages
Back to the Benderlink Page
Hardware for making the connection: Benderlink Ethernet Module for PINES to Vector
