Difference between revisions of "Feed Axis Faults During Feed Bending"
(→Details) |
|||
| Line 4: | Line 4: | ||
* The Feed Axis faults especially on large angle bends | * The Feed Axis faults especially on large angle bends | ||
* The Feed Axis does NOT fault when moving the bender through the cycle with no material in the machine. | * The Feed Axis does NOT fault when moving the bender through the cycle with no material in the machine. | ||
| − | + | <br> | |
| − | == | + | ==Diagnostics== |
<table> | <table> | ||
Revision as of 20:52, 15 July 2009
During Feed-Bending it is possible to experience a Feed Axis Fault that is caused by the wrong tool radius values or an incorrect Feed Axis Adjust % value. Both are in the Tool Page.
Quick indicators that should make you suspect that this is the case:
- The Feed Axis faults especially on large angle bends
- The Feed Axis does NOT fault when moving the bender through the cycle with no material in the machine.
Diagnostics
|
Possible Problem: The Centerline Radius values do not to match the bend die radii on the bender.
|
|
|
Possible Problem: The Feed Axis Adjust % Value is not set to the proper value in the Tool page.
That calculates to -14% elongation |
|
