Difference between revisions of "Feed Axis Faults During Feed Bending"
(→Diagnostics) |
|||
| Line 6: | Line 6: | ||
<br> | <br> | ||
| − | == | + | ==Diagnostic 1== |
<table> | <table> | ||
<tr> | <tr> | ||
<td width="200"> | <td width="200"> | ||
| + | CHECK THE CENTERLINE RADIUS in the Tool Page.<br> | ||
Possible Problem: The Centerline Radius values do not to match the bend die radii on the bender. | Possible Problem: The Centerline Radius values do not to match the bend die radii on the bender. | ||
<br><br> | <br><br> | ||
| Line 22: | Line 23: | ||
</table> | </table> | ||
| + | < | ||
<table> | <table> | ||
<tr> | <tr> | ||
Revision as of 20:52, 15 July 2009
During Feed-Bending it is possible to experience a Feed Axis Fault that is caused by the wrong tool radius values or an incorrect Feed Axis Adjust % value. Both are in the Tool Page.
Quick indicators that should make you suspect that this is the case:
- The Feed Axis faults especially on large angle bends
- The Feed Axis does NOT fault when moving the bender through the cycle with no material in the machine.
Diagnostic 1
|
CHECK THE CENTERLINE RADIUS in the Tool Page. |
|
<
|
Possible Problem: The Feed Axis Adjust % Value is not set to the proper value in the Tool page.
That calculates to -14% elongation |
|
