Difference between revisions of "Feed Axis Faults During Feed Bending"
(→Diagnostic 2 - Check the Feed Axis % Values) |
(→Diagnostic 2 - Check the Feed Axis % Values) |
||
| (2 intermediate revisions by one user not shown) | |||
| Line 32: | Line 32: | ||
Here's an example: | Here's an example: | ||
| − | *At Feed Adjust Percent of 0%, the calculated feed motion for 155.6 degrees of bend is 8.1"<br> | + | *At Feed Adjust Percent of 0%, the calculated feed motion for 155.6 degrees of bend is 8.1"<br><br> |
| − | *However the actual motion of the Feed axis is 7.5"<br> | + | *However the actual motion of the Feed axis is 7.5"<br><br> |
| − | *The Feed Adjust Percent is therefore -7.4<br> | + | *The Feed Adjust Percent is therefore -7.4<br><br> |
| − | < | + | |
Enter that value into the Feed Adjust Percent field and press AutoBuild | Enter that value into the Feed Adjust Percent field and press AutoBuild | ||
| Line 44: | Line 44: | ||
</tr> | </tr> | ||
</table> | </table> | ||
| + | |||
| + | ==Other Pages== | ||
| + | *Back to [[CNC Bender Technical Notes]] | ||
Latest revision as of 21:00, 15 July 2009
During Feed-Bending it is possible to experience a Feed Axis Fault that is caused by the wrong tool radius values or an incorrect Feed Axis Adjust % value. Both are in the Tool Page.
Quick indicators that should make you suspect that this is the case:
- The Feed Axis faults especially on large angle bends
- The Feed Axis does NOT fault when moving the bender through the cycle with no material in the machine.
Diagnostic 1 - Check the Bend Die Radius Values
|
Possible Problem: The Centerline Radius values do not to match the bend die radii on the bender.
|
|
Diagnostic 2 - Check the Feed Axis % Values
|
Possible Problem: The Feed Axis Adjust % Value is not set to the proper value in the Tool page.
Enter that value into the Feed Adjust Percent field and press AutoBuild |
|
Other Pages
- Back to CNC Bender Technical Notes
