• The hopper and slide-loader setup is simplified by breaking the HOPPER enable/disable away from the SIDE LOADER.
  
  
• The standard side-loader HSL1 is renamed to a much easier to understand "AL (AutoLoader)".
  
  
• Several new Low Level options (using a prefix of "AL") are added or renamed to ease the setup the AutoLoader with a hopper.
  
  
• New AutoLoader and Hopper options in PreBend.
  
  

The new Kicker option allows for easy setup of a kicker actuator that kicks the part off the bender at the end of the bend cycle.

• Set the Kicker COMDEF names in Low Level
  
  
• Enable the Kicker with the Kicker Mode option in the PostBend section of Bender Data.

The option speed edit button now defaults to the UP (off) position whenever an option list loads to the screen.

Operators prefer that the button default state to be off during data REVIEW, but possibly ON during setup and editing.