Difference between revisions of "CNC Bender v11-20090729"
From ATTWiki
| (5 intermediate revisions by one user not shown) | |||
| Line 10: | Line 10: | ||
<td width="200"> | <td width="200"> | ||
* The hopper and slide-loader setup is simplified by breaking the HOPPER enable/disable away from the SIDE LOADER.<br><br> | * The hopper and slide-loader setup is simplified by breaking the HOPPER enable/disable away from the SIDE LOADER.<br><br> | ||
| − | * The standard side-loader HSL1 is renamed to AL (AutoLoader).<br><br> | + | * The standard side-loader HSL1 is renamed to a much easier to understand "AL (AutoLoader)".<br><br> |
| − | * Several new Low Level options (using a prefix of "AL") are added or renamed to ease the setup the AutoLoader with a hopper.<br><br> | + | * Several new Low Level options (using a prefix of "AL") are added or renamed to ease the setup the AutoLoader with or without a hopper.<br><br> |
* New AutoLoader and Hopper options in PreBend.<br><br> | * New AutoLoader and Hopper options in PreBend.<br><br> | ||
</td> | </td> | ||
| Line 17: | Line 17: | ||
[[image:cncbender_AL_dynamicoptions.jpg|500px]]<br><br> | [[image:cncbender_AL_dynamicoptions.jpg|500px]]<br><br> | ||
[[image:cncbender_prebend_autoloader_features.jpg|500px]]<br> | [[image:cncbender_prebend_autoloader_features.jpg|500px]]<br> | ||
| + | </td> | ||
| + | </tr> | ||
| + | </table> | ||
| + | |||
| + | ===[[image:Check.jpg|25px]] NEW - Kicker Options === | ||
| + | |||
| + | <table> | ||
| + | <tr> | ||
| + | <td width="200"> | ||
| + | The new Kicker option allows for easy setup of a kicker actuator that kicks the part off the bender at the end of the bend cycle.<br><br> | ||
| + | *Set the Kicker COMDEF names in Low Level<br><br> | ||
| + | *Enable the Kicker with the Kicker Mode option in the PostBend section of Bender Data. | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:cncbender_kicker_lowlevel.jpg|500px]]<br><br> | ||
| + | [[image:cncbender_kicker_postbend.jpg|500px]]<br><br> | ||
</td> | </td> | ||
</tr> | </tr> | ||
Latest revision as of 20:10, 19 August 2009
REDESIGN - Hopper and Side Loaders Setup Simplified
|
|
NEW - Kicker Options
|
The new Kicker option allows for easy setup of a kicker actuator that kicks the part off the bender at the end of the bend cycle.
|
|
ENHANCED - Option Speed Edit Button
|
The option speed edit button now defaults to the UP (off) position whenever an option list loads to the screen. |
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- Read about Push Bending
- Read about Push Bend Profile Tables
