Difference between revisions of "End Cycle Mode"
From ATTWiki
| Line 1: | Line 1: | ||
| − | |||
<table cellpadding=10 width=600> | <table cellpadding=10 width=600> | ||
<tr> | <tr> | ||
| Line 18: | Line 17: | ||
</tr> | </tr> | ||
| − | </table> | + | </table> |
Revision as of 21:40, 26 August 2009
| End Cycle Mode Purpose | Detailed Explanation |
| For Tail-Out | Since CNC Bender can run scores of processes simultaneously, the END CYCLE mode is "tail-out" feature that allows all the processes to pause at the end of running the cycle in order to allow an... |
| Orderly Shutdown | ...orderly shut-down of all mechanisms controlled by CNC Bender. This would especially apply to hoppers, loaders of all types, unloaders, and other secondary processes that run around the machine. |
