Difference between revisions of "End Cycle Mode"
From ATTWiki
(→Other Pages) |
|||
| (4 intermediate revisions by one user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[image:Cncbender_logo_pushbending.png]] | ||
| + | [[image:Operatorstation_model.jpg|right]] | ||
| + | |||
| + | |||
| + | |||
<table cellpadding=10 width=600> | <table cellpadding=10 width=600> | ||
<tr> | <tr> | ||
<td bgcolor="#abbad1" width=150><b>End Cycle Mode Purpose</b></td> | <td bgcolor="#abbad1" width=150><b>End Cycle Mode Purpose</b></td> | ||
<td bgcolor="#e3e4f5">Detailed Explanation</td> | <td bgcolor="#e3e4f5">Detailed Explanation</td> | ||
| + | <td></td> | ||
| + | |||
</tr> | </tr> | ||
| Line 8: | Line 15: | ||
<td>For Tail-Out</td> | <td>For Tail-Out</td> | ||
<td>Since CNC Bender can run scores of processes simultaneously, the END CYCLE mode is "tail-out" feature that allows all the processes to pause at the end of running the cycle in order to allow an... | <td>Since CNC Bender can run scores of processes simultaneously, the END CYCLE mode is "tail-out" feature that allows all the processes to pause at the end of running the cycle in order to allow an... | ||
| + | </td> | ||
| + | <td> | ||
| + | [[image:cncbender_endcycle.jpg]] | ||
</td> | </td> | ||
</tr> | </tr> | ||
| Line 14: | Line 24: | ||
<td>Orderly Shutdown</td> | <td>Orderly Shutdown</td> | ||
<td>...orderly shut-down of all mechanisms controlled by CNC Bender. This would especially apply to hoppers, loaders of all types, unloaders, and other secondary processes that run around the machine.<br><br> | <td>...orderly shut-down of all mechanisms controlled by CNC Bender. This would especially apply to hoppers, loaders of all types, unloaders, and other secondary processes that run around the machine.<br><br> | ||
| + | </td> | ||
| + | <td> | ||
</td> | </td> | ||
</tr> | </tr> | ||
| Line 24: | Line 36: | ||
*Back to [[CNC Bender Software Updates]] | *Back to [[CNC Bender Software Updates]] | ||
*See CNC Bender upgrade [[CNC Bender v11-20090826]] | *See CNC Bender upgrade [[CNC Bender v11-20090826]] | ||
| + | |||
| + | ---- | ||
Latest revision as of 22:21, 26 August 2009
| End Cycle Mode Purpose | Detailed Explanation | |
| For Tail-Out | Since CNC Bender can run scores of processes simultaneously, the END CYCLE mode is "tail-out" feature that allows all the processes to pause at the end of running the cycle in order to allow an... |
|
| Orderly Shutdown | ...orderly shut-down of all mechanisms controlled by CNC Bender. This would especially apply to hoppers, loaders of all types, unloaders, and other secondary processes that run around the machine. |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender upgrade CNC Bender v11-20090826
