Difference between revisions of "CNC Bender v11-200900915"
From ATTWiki
(→25px ENHANCED - New Pressure Die Advanced Timer Choice in Processlist Builder) |
|||
| Line 11: | Line 11: | ||
<br><br> | <br><br> | ||
| − | For example, if the PDA Mode is set to Follower / No Prox, then the Processlist Builder will switch to use the new "PressureDieAdvanceWithTimer Without PDA" command like this: | + | For example, if the PDA Mode is set to '''Follower / No Prox''', then the Processlist Builder will switch to use the new "PressureDieAdvanceWithTimer Without PDA" command like this: |
<font size=2><pre> | <font size=2><pre> | ||
Revision as of 15:26, 15 September 2009
ENHANCED - New Pressure Die Advanced Timer Choice in Processlist Builder
The pressure die advance timer choice in the Processlist Builder is now dependent on the Pressure Die Assist setup in the Low Level General Dynamic Options list.
For example, if the PDA Mode is set to Follower / No Prox, then the Processlist Builder will switch to use the new "PressureDieAdvanceWithTimer Without PDA" command like this:
PressureDieAdvanceWithTimer Without PDA = tim2:500, cto:6000
ENHANCED - File Path in FRB Page Synchronizes With Low Level Path Settings
When the part path changes in the low level File Paths menu, the path also now automatically changes in the FRB page in Bender Data.
ENHANCED - Processlist Builder Screen Update
The Processlist Builder has an updated screen.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See Cycle Hold
- See Hopper Logic
- See Processlist
- See Secondary Processlist
