Difference between revisions of "CNC Bender v11-20091007"
From ATTWiki
Line 12: | Line 12: | ||
===[[image:Check.jpg|25px]] NEW - Spacebar Filter Mode === | ===[[image:Check.jpg|25px]] NEW - Spacebar Filter Mode === | ||
+ | <table> | ||
+ | <tr> | ||
+ | <td width=300> | ||
Pressing the spacebar in Windows causes any focused button to "click." This can cause manual jog moves with the press of the spacebar. Some users prefer that this Windows feature be disabled for better safety. | Pressing the spacebar in Windows causes any focused button to "click." This can cause manual jog moves with the press of the spacebar. Some users prefer that this Windows feature be disabled for better safety. | ||
<br><br> | <br><br> | ||
Line 18: | Line 21: | ||
*When CNC Bender is in the Low Level menu. | *When CNC Bender is in the Low Level menu. | ||
*When the CNC Bender numeric keypad is active. | *When the CNC Bender numeric keypad is active. | ||
+ | </td> | ||
+ | |||
+ | <td> | ||
+ | [[image:operatorstation_top.jpg]] | ||
+ | </td> | ||
+ | |||
+ | </tr> | ||
+ | </table> | ||
<br><br> | <br><br> |
Revision as of 13:06, 7 October 2009
NEW - Low Level - Rotate Reset Mode
The Rotate Reset Mode controls if the rotate axis is reset to zero between every bend by default. If you intend to use Absolute Pre-Rotate Enable with multiple parts in the Runlist, and the axis should never reset itself except when homing, then the Rotate Reset mode can be set to DISABLE.
The default mode is ENABLED.
NEW - Spacebar Filter Mode
Pressing the spacebar in Windows causes any focused button to "click." This can cause manual jog moves with the press of the spacebar. Some users prefer that this Windows feature be disabled for better safety.
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Absolute Rotate
- See Absolute Rotate Offset Position
- See Final Feed Clearance
- See Mandrel Retract
- See Mandrel Retract Part Release