Difference between revisions of "CNC Bender v11-20091104"
From ATTWiki
Line 32: | Line 32: | ||
* Every part process list begins with an initialization section that can easily be 50 lines of commands. Running through these commands for the same part repeatedly when starting the next part cycle wastes time. <br><br> | * Every part process list begins with an initialization section that can easily be 50 lines of commands. Running through these commands for the same part repeatedly when starting the next part cycle wastes time. <br><br> | ||
− | * | + | * So this version includes a new [BEGIN RUN AGAIN] label placed in the middle of each part's process list to trim off processing time by showing CNC Processor where to start when the same part is run the second time and greater.<br><br> |
* The result is to trim seconds of each cycle. | * The result is to trim seconds of each cycle. | ||
</td> | </td> |
Revision as of 22:36, 4 November 2009
NEW - Final Bend Simultaneous Motion
|
NEW - New Optimization in Processor - Makes Bender Run Faster
|
NEW - Second Constant Run List Designed for HIGH SPEED
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Absolute Rotate
- See Absolute Rotate Offset Position
- See Final Feed Clearance
- See Mandrel Retract
- See Mandrel Retract Part Release