Difference between revisions of "CNC Bender v11-20091118"
From ATTWiki
| Line 65: | Line 65: | ||
===[[image:Check.jpg|25px]] ENHANCE - AllDiesToHome Command and AllDiesToHomeWithoutPDA Commands=== | ===[[image:Check.jpg|25px]] ENHANCE - AllDiesToHome Command and AllDiesToHomeWithoutPDA Commands=== | ||
| − | * Both of these commands can be changed/named in the General Dynamic Option List in Low Level. | + | * Both of these commands can now be changed/named in the General Dynamic Option List in Low Level. |
* When returning a PDA motion-controlled axis, then AllDiesToHomeWithoutPDA is called immediately after in order to insure that the pressure die and clamp dies are home. | * When returning a PDA motion-controlled axis, then AllDiesToHomeWithoutPDA is called immediately after in order to insure that the pressure die and clamp dies are home. | ||
| + | |||
| + | <br><br> | ||
=Other Pages= | =Other Pages= | ||
Revision as of 12:45, 19 November 2009
|
|
|
REPAIR- Final Bend Simultaneous Motion
|
|
REPAIR- Time-Out Value for Bend Arm Return
|
ENHANCE - AllDiesToHome Command and AllDiesToHomeWithoutPDA Commands
- Both of these commands can now be changed/named in the General Dynamic Option List in Low Level.
- When returning a PDA motion-controlled axis, then AllDiesToHomeWithoutPDA is called immediately after in order to insure that the pressure die and clamp dies are home.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender v11-20091104
- See CNC Bender General Information
- See Absolute Rotate
- See Absolute Rotate Offset Position
- See Final Feed Clearance
- See Mandrel Retract
- See Mandrel Retract Part Release
