Revision as of 22:41, 23 November 2009

Type of Upgrade: FLEXIBILITY

The changes in this version are additions to CNC Bender for better editing and reporting.

The new editor in Low Level allows you to edit the new High Speed Constant Run Processlist.

The part count updated normally except whenthe Runlist Run is complete. This is corrected.

@@ Line 75: / Line 75: @@
 <br><br>
-===[[image:Check.jpg|25px]] ENHANCE - AllDiesToHome Command and AllDiesToHomeWithoutPDA Commands===
+===[[image:Check.jpg|25px]] REPAIR- Counter in RunPage is Updated to Zero When Run is Complete===
 <table>
 <tr valign=top>
 <td width=300>
-* Both of these commands can now be named in the General Dynamic Option List in Low Level.<br><br>
+* The part count updated normally except whenthe Runlist Run is complete.  This is corrected.
-* Automated logic has been installed to work like this:
 </td>
 <td width=450>
+[[image:runpage_counter.jpg|450px]] <br><br>
-[[image:COMDEFname_alldiestohome.jpg|450px]] <br><br>
-<table cellpadding=5>
-<tr>
-<td width=150 bgcolor="#abbad1">
-* When returning a PDA motion-controlled axis...<br><br>
-* When using a FOLLOWER with NO prox...
 </td>
-<td bgcolor="#e3e4f5">
-...then AllDiesToHomeWithoutPDA is called immediately after in order to insure that the pressure die and clamp dies are home before continuing.
-</td>
 </tr>
 </table>
-<table cellpadding=5>
-<tr>
-<td width=150 bgcolor="#abbad1">
-* When returning a PDA directional valve actuator...<br><br>
-* When returning a FOLLOWR with a prox switch...
-</td>
-<td bgcolor="#e3e4f5">
-...then AllDiesToHome is called to be sure the pressure die, clamp die, and Pressure Die Assist die are home before continuing.
-</td>
-</tr>
-</table>
-</td>
-</tr>
-</table>
 <br><br>

Difference between revisions of "CNC Bender v11-20091123"