Difference between revisions of "CNC Bender v11-20091201"
From ATTWiki
| Line 30: | Line 30: | ||
<tr valign=top> | <tr valign=top> | ||
<td width=300> | <td width=300> | ||
| − | * CNC Bender now allows logic to make a button into a toggle.<br><br> | + | * CNC Bender now allows logic to make a physical momentary push-button into a toggle switch. For example, push the button to switch a state on, then push it again to switch the state off.<br><br> |
* For example, it is possible to use logic in the Constant Run processlist to switch a End Cycle ON and OFF using a push button.<br><br> | * For example, it is possible to use logic in the Constant Run processlist to switch a End Cycle ON and OFF using a push button.<br><br> | ||
Revision as of 03:31, 2 December 2009
|
|
|
NEW- Logic Allows Push Buttons to Toggle States
|
|
NEW- Editor for High Speed Constant Run Processlist
|
|
NEW- Better Warning for Missing Processlists
|
|
UPDATE- Improved Grids in Dynamic Option Lists
|
|
REPAIR- Counter in RunPage is Updated to Zero When Run is Complete
|
|
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender v11-20091104
- See CNC Bender General Information
- See Absolute Rotate
- See Absolute Rotate Offset Position
- See Final Feed Clearance
- See Mandrel Retract
- See Mandrel Retract Part Release
